Vola Cutofino 2 File 100 x 25 mm Cut 2 Super Fine

The Vola Cutofino 2 is the hard-chromed edge file for the finishing touch: 100 x 25 mm, Cut 2 with 16 teeth per centimeter—so it’s super-fine. It removes very little steel and leaves an edge that’s smooth and clean, without deep gouges. The chrome coating keeps the teeth sharp for a long time, prevents rust, and is easy to clean. The file for racers, ski service professionals, and anyone who rides on hard slopes with sharp edges. Fits into the Vola edge angle and all file holders with a 25 mm shank.

Vola Cutofino 2: super-fine file with 16 teeth per cm

After pre-sharpening with a coarser file, the edge is sharp, but the surface still has scratches that slow you down on hard snow and ice and cause the edge to dull more quickly. The Cutofino 2 smooths out these grooves with 16 teeth per centimeter before the diamond stone removes the burr. The result is an edge that grips cleanly on ice and stays sharp longer. The hard chrome plating sets it apart from regular files: the fine teeth stay sharp for months, the file doesn’t rust, and shavings don’t get stuck as easily. At 100 mm long, it’s compact enough to fit in your jacket pocket on race day.

Features in Detail

• √ Edge file 100 x 25 mm, Cut 2, 16 teeth per cm, super fine
• √ Hard chrome-plated: stays sharp for a long time, rust-free, easy to clean
• √ For sidewall and base edge angles, as well as file holders with a 25 mm shank
• √ For alpine skis, touring skis, cross-country skis, and snowboards
• √ Made in the EU, Vola Racing

Application

Clamp the file into the Vola Racing edge angle or another file holder, secure the ski or board in the clamp, and file the edge with light pressure in the direction of travel from the tip to the tail, always in the same direction. With the fine file, just a few strokes are enough. Then remove the burr with a diamond stone and slightly round off the edge at the tip and tail. Clean the file with a file brush after use.

Uses

For fine-tuning racing skis, for sharpening before the start, and for anyone who wants a smooth, long-lasting edge. For dull or damaged edges, start with the Cutofino 1 or a workshop file, then finish sharpening with the Cutofino 2.