Colltex end hook Hexagon

The practical mounting set consisting of 2 elastic cords, 2 folding cord stoppers, 2 washers.

These colltex adhesive pads help quickly when the ski skins come off or the adhesive surface is dirty in some places. Set of 10 sheets (60 x 75mm)

The "hotmelt tape" is the best way to completely recoat the ski skin with a hotmelt adhesive layer. If possible, first remove old glue residue and dirt from the adhesive layer of the ski skin. Unroll the tape at room temperature with the foil side down to the length of the ski and fix the ends. Stick the ski skin with the adhesive layer onto the hotmelt tape and press it down lightly. Now cut the tape to the correct size along the edge of the ski skin. Now turn the ski skin and heat the tape with an iron at approx. 120 degrees slowly and with light pressure. This transfers the adhesive. Allow it to cool well before removing the film and attaching the cover net to the adhesive layer.

Fastening system for ski skins. Can be easily clamped to the end of any ski. Camlock by Colltex is a fastening system for Colltex ski skins. It is made of unbreakable plastic and stainless steel and can be used with any ski end.

2 skin stirrups with tip caps including top and bottom rivets for self-assembly. Suitable for all ski models.

2 skin stirrups EVO with tip caps for all ski models.

Jones Nomad PRO Skins are the ultimate high performance splitboard skins for all snow conditions. The Nomad Pro skin fibers are a blend of 70% mohair and 30% synthetic nylon fibers. This combination of natural and synthetic fibers provides the perfect balance of glide, grip and durability. Nomad Pro skins are PFC-free and have been coated with both the Bluesign-approved EVER DRY 3.0 anti-glapping treatment to improve wet snow performance and the GLIDE TECH treatment, which helps maintain glide for the life of the skin. Jones Nomad skins are also laminated with a RUBBER SAFER SKIN backing. This rubber layer prevents the skin from absorbing water and makes it easier to pull the skins apart. Ready for immediate use: Pre-cut skins do not need to be trimmed. The Quick Tension Tail Clip is attached to the skin. The Quick Tension Tail Clip adjusts in seconds, ensures perfect skin tension and is compatible with all Jones splitboards from 2016. Clip A - Jones Womens Solution 146, 149, 152, 155 - Jones Dreamcatcher 145, 148, 151, 154 - Jones Hovercraft 146 Clip B - Ultra Solution 158, 161 - Solution 154, 158, 161 Clip D - Jones Mountain Twin Split 157, 159, 160 Clip F - Jones Ultra Solution 162W - Jones Solution 162W, 167 Clip G - Jones Ultra Solution 165W Clip O - Jones Escape 156L, 159L, 162W

Self-assembly set with 2 Hexagon end hooks, 2 perforated straps, 6 top and bottom rivets.

The perfect assembly set consisting of 2 camlock end hooks, 2 perforated straps, 6 rivet heads and 6 rivet bases. Center the camlock strap on the adhesive layer and press firmly. Pierce through the pre-punched holes with riveting pliers or an awl. Push the lower parts of the rivets through the holes, place the rivet heads on and tap the rivets together with a hammer. Cut the ski skin at the back up to the contact zone on both sides. 2 End hooks 2 perforated straps 6 rivets + carpet pad

Cleaner for ski tour skins and Nordic climbing skins.Gently cleans the skins of dirt and wax residues. Climbing and gliding properties are improved again. The cleaner does not attack the skins' adhesive. Application: Moisten Care Fleece with Skin Cleaner. Gently clean the skins in the direction of travel.